Home

How to Check Ventilation Before Choosing a Flat

To check ventilation before choosing a flat, test how air moves through each room, inspect how far the windows open, and check where kitchen and bathroom exhausts discharge air. Look for stale smells, damp patches and blocked airflow, then confirm that outside air can enter without you having to leave the main entrance door open.

How to test airflow during a flat visit

Ask for air conditioners, ceiling fans and fragrance dispensers to be switched off before you inspect the flat. Notice how the air smells and feels when you first enter, before anyone opens all the windows or runs the exhaust fans.

Open the windows you would normally use and keep internal doors in their usual positions. Hold a thin strip of tissue near each opening to see whether air moves, then repeat the check at bedroom doorways and towards the centre of deeper rooms. This shows you local air movement, not a measured ventilation rate.

Follow these steps to compare rooms:

  1. Check each room with its door open and then closed.
  2. Open a second window on another side of the flat and look for a change in airflow.
  3. Check whether curtains, wardrobes or fixed partitions block airflow between openings.
  4. Repeat the test with kitchen and bathroom exhaust fans running.

A ceiling fan can make you feel comfortable while mainly moving the same indoor air. Air movement is not air replacement: the US Environmental Protection Agency identifies bringing outside air indoors as one way to improve indoor air quality. A brief tissue test cannot tell you whether the flat receives enough fresh air throughout the day.

How to check windows for cross-ventilation

Look for a clear cross-ventilation path, with openings on different sides that allow air to enter and leave. Windows on opposite or adjacent external walls can provide this path, although actual airflow depends on pressure differences and surrounding obstructions.

Judge how far the window opens, not the size of the glass. Fixed glazing provides no ventilation, and a sliding window may open only part of its total width. Test every openable section and check whether safety restrictors, insect mesh or external grilles substantially reduce the opening available for airflow.

Stand at each window and look outside. A nearby wall, enclosed balcony or narrow shaft may limit air exchange. Also check for vehicle exhaust, waste areas or another flat’s exhaust outlet near the opening, since outside air is not necessarily clean.

Check bedrooms with their doors shut, particularly if you expect to keep them closed while sleeping. You may notice very different airflow once you close a door connecting the bedroom to another room. You shouldn't have to leave the main entrance open to ventilate the flat.

How to check kitchen and bathroom exhaust fans

Switch on each exhaust fan separately. Hold a tissue near the grille without removing the cover or touching moving parts; the suction should draw it towards the exhaust grille. Noise alone does not prove that the fan extracts air, and suction at the grille does not confirm that the fan has enough capacity or that its discharge route is clear.

Ask to see where the duct discharges. It should not simply end inside a false ceiling or another enclosed indoor space. If ducts connect to shared shafts, ask the maintenance team how the system prevents extracted air and odours from entering neighbouring flats.

For the kitchen, check whether the chimney extracts air outdoors or recirculates filtered air. A recirculating unit does not provide the same ventilation as outdoor extraction. Check the filters and ask whether you can access the duct for inspection and cleaning.

In an internal bathroom, look for a way for replacement air to enter, such as a purpose-designed gap under the door or a transfer grille. An exhaust fan needs incoming air to replace what it removes; a tightly closed room can restrict extraction.

Signs of dampness and poor ventilation

Inspect corners, the recesses around windows, ceilings, the backs of accessible cupboards and walls beside bathrooms. Use a torch where necessary, but ask permission before moving furniture. Look out for:

  • Musty smells that persist after you open the windows.
  • Visible mould, peeling paint or swollen cabinet panels.
  • Water marks or staining around windows and ceiling edges.
  • Condensation on glass or other cool surfaces.
  • Strong cooking or bathroom smells entering from neighbouring flats.

Investigate these signs rather than assuming poor ventilation is the cause. Dampness can indicate a leak, not just poor ventilation. The US Environmental Protection Agency’s guide to mould and moisture stresses fixing the moisture source as part of mould control.

Ask about recent repainting and previous seepage repairs. If staining keeps returning, or you notice extensive visible mould, request an independent building inspection. Don't accept repainting as proof that someone has fixed the underlying problem.

How to check the fresh-air supply

Don't assume a split AC or air purifier supplies fresh air. Most domestic split AC systems recirculate room air, while an air purifier filters the air passing through it. Ask specifically whether the installed system includes an intake designed to bring in outside air.

If the flat uses a mechanical fresh-air supply or whole-home ventilation system, request the operating instructions, filter replacement requirements and service records. Check which equipment serves your flat, who maintains it and whether you can run it independently.

For a flat under construction, ask for the approved layout and ventilation drawings. Check that the proposed window openings, exhaust routes and any balcony enclosure match what you will actually receive. Get any promises to make corrections in writing; if you're unsure about contractual obligations, consult a qualified property lawyer.

When to get a professional ventilation assessment

Before you commit, arrange a second visit at a different time, with windows and doors set as you expect to use them. Consider privacy and noise: a window provides little practical ventilation if you will usually keep it shut.

Seek an independent building-services engineer’s assessment if you still have doubts about airflow, internal rooms depend entirely on mechanical systems, or shared ducts cause recurring odours. Ask the engineer to measure supply and extract airflow and assess it against the applicable design requirements. Do not rely on smell alone to judge whether ventilation is adequate.

Sources